Home > Drone Systems > XRotor Nano 20A 4in1 BLHeli-S DShot600
XRotor Nano 20A 4in1 BLHeli-S DShot600

Highly Integrated & Compact

The XRotor Nano 20A 4in1 BLHeli-S DShot600 not only includes 4
high-performance 20A ESCs, but also a volt monitoring port which allows FC to
monitor the voltage in real time (on condition that the FC supports this function).
With the incredibly small size, the installation and wiring can be very simple
and easy when pairing it with the Hobbywing XRotor Nano Flight Controller.
It’s an ESC specially designed for super mini-sized indoor FPV(s).

Highly Integrated
& Compact

XRotor Nano 20A 4in1 BLHeli-S DShot600

High-quality Components

The use of EMF8BB21F16G MCUs with the operating frequency of up to
48MHz, imported high quality MOSFETs, 3-in-1 drive ICs and ceramic
capacitors, 3-ounce copper, and 6 layers of PCBs guarantees less heat,
higher efficiency and rapider response.

High-quality
Components

Imported Top Quality MOSFETs

3-in-1 Drive ICs

The use of EMF8BB21F16G MCUs

BLHeli-S Firmware Ready

The ESC (with great performance and rich functions)
uses the original BLHeli-S firmware and supports adjusting
parameters or upgrading firmware via different methods
(i.e. via throttle signal wire with using other development board
or a FC flashed with the Cleanfight / Betaflight firmware).

BLHeli-S
Firmware Ready

DShot150/300/600 Ready

Besides the regular PWM mode,
Oneshot125/Oneshot42/Multishot modes, the latest
DShot150/300/600 modes are also supported. In
DShot150/300/600 modes, the ESC has great
anti-interference performance and rapid response.

DShot150/300/600 Ready

Hardware Generated PWM &
Damped Light Mode

The ESC firmware uses hardware generated motor pwm for smooth
throttle response and silent operation. Damped light does regenerative
breaking, causing very fast motor retardation, and it inherently also
does active freewheeling.

Hardware Generated PWM
& Damped Light Mode

返回顶部